The machining centre is equipped with a pin-table and two 5-axis working unit. The torque support is fixed to the working unit where additional heads from the tool magazine can be used at any angular position.
The milling motors are provided with a blasting nozzle which can be activated or deactivated by the NC-control system. Two additional slides for the units are located inside the machine bed at its front longitudinal side that can be displaced by separate NC-axes in the X-, Y-, and Z-direction. On each unit slide there are two milling-drilling motors with fixed tools that can be placed separately of each other.
The automatic chain changer for 60 tools is installed inside the portal housing behind the working unit. A cover hood protects the tool cones from flying chips.
At right angles the deviation within one metre is only 0.1 mm. If a working step is repeated in the same axis, this deviation will even be reduced to 0.05 mm.
